Table of Contents
Advertisement
The S5810 series use hot swappable fan trays. When a fan tray failure occurs, you can follow these
steps to replace the fan tray.
Removing a Fan Tray
You can replace a hot swappable fan tray without powering off the device. To prevent overheat, you are
recommended to complete replacing the fan tray within two minutes.
1)
Wear an ESD-preventive wrist strap, make sure that the wrist strap has a good skin contact and is
well grounded.
2)
Loosen the screw on the fan tray with a Phillips screwdriver until the screw is completely separated
from the device, as shown in
Figure 6-1 Remove an LSW1BFAN (1)
3)
Holding the handle of the fan tray with one hand, pull part of the fan tray out. Then supporting the
bottom of the fan tray with the other hand, pull it straight out of the fan tray slot along the guide rails,
as shown in
Figure 6-2 Remove an LSW1BFAN (2)
Figure
Figure
6-2.
6-1.
6-3
Advertisement
Table of Contents
