Table of Contents
Advertisement
Attaching the Mounting Brackets to a Switch
The mounting brackets can be attached to a switch for center, front, or rear mounting. You can choose a
proper position according to the actual requirements.
1)
Fix the left and right mounting brackets respectively to the left and right sides of the chassis.
3-3,
Figure
and rear mounting (because the installation procedures of the two brackets are the same, each
figure shows only how to install one bracket).
2)
Fasten the M4x8 screws.
Figure 3-3 Attach the mounting bracket to an S5810 for front mounting
Figure 3-4 Attach the mounting bracket to an S5810 for center mounting
Figure 3-5 Attach the mounting bracket to an S5810 for rear mounting
Mounting the Switch to a Rack
1)
Wear an ESD-preventive wrist strap and make sure the rack is well grounded and is firm enough to
hold the switch and cables.
2)
Attach the mounting brackets to the switch. For details, refer to
a
Switch.
3)
Hold the bottom of the switch and gently place the switch on the rack to a proper location with one
person.
4)
Fix the mounting brackets with screws (anti-rust screws prepared by yourself) with another person
to install the switch to the rack horizontally.
3-4, and
Figure 3-5
show how to install the brackets for front mounting, center mounting,
Attaching the Mounting Brackets to
3-2
Figure
Advertisement
Table of Contents
