Programming Dss/Blf Buttons; Resetting Programmable Buttons - Mitel 8500 Endpoint User Manual

Programming DSS/BLF Buttons

You can use programmable buttons as Direct Station Selection/Busy Lamp Field (DSS/BLF)
buttons. DSS/BLF buttons must be enabled by your system administrator.
After you program a DSS/BLF button, you can:
•
•
•
Continuously lit
Slowly flashing
Quickly flashing
Continuously flashing
To assign a DSS/BLF button:
1. With the handset on-hook, dial 397.
2. Press the programmable button, and then enter the extension number to be assigned to

Resetting Programmable Buttons

You can reset programmed buttons to the default assignments. Resetting the programmable
buttons does not reset button assignments programmed by the system administrator.
To reset the feature buttons to the default values:
Mitel ® Model 8500 User Guide – Issue 12, October 2008
Press the button to place a call to the assigned extension.
Press the button and then hang up to transfer a call to the assigned extension. If the call is
transferred to voice mail you hear repeating double tones.
Visually monitor the call activity of the assigned extension. The following lamp signals
indicate call activity.
Lamp Signal
the button.
With the handset on-hook, dial 395.
Description
The extension is busy or off-hook.
The extension is in Do-Not-Disturb (DND).
The extension has a call ringing in.
The extension is causing a "Station Off-Hook" system alarm.
Personalizing Your Endpoint
Page 11