Operations On Clutch Cover; Starter - Husqvarna CR 50 / 2011 Workshop Manual

ENGINE

Operations on clutch cover

Clutch cover shall be removed only if some parts are faulty or if the
O-ring has lost is sealing capacity.
- Turn kick start pedal shaft (1) against spring strength (counterclockwise),
and remove starter engagement gear (2), then check teeth for wear.
Should it be necessary to remove kick start pedal shaft, remove
outer circlip and take kick start pedal shaft out from cover with extreme
care.
Kick start pedal spring is preloaded so, when removing kick start
pedal shaft, it shall be released.
Clean kick start pedal shaft, and remove the old oil seal (5) with a suitable
tool, then replace it with a new one to be pressed inside its seat flush with
the surface.
Upon reassembly, push kick start pedal shaft inside clutch cover just enough
to hook spring (6 and 7). Turn kick start pedal shaft counterclockwise to load
spring, and just after this operation you can fully install kick start pedal shaft
inside clutch cover. Keep kick start pedal shaft turned, fit starter engagement
gear, and release shaft.
To prevent kick start pedal shaft from hitting clutch cover, shaft tooth-
ing features a distorted end (8) engaging with starter gear. There shall
always be a gap between kick start pedal shaft and stopper (9).
F.12
Ed. 01-09-2010