Ignition System Values Reading; Stator; Ignition Coil; Peak Voltage Adapter - Husqvarna CR 50 / 2011 Workshop Manual

FAULT
Gearbox oil coming out of
breather pipe
Ed. 01-09-2010
CAUSE
Too much gearbox oil

IGNITION SYSTEM VALUES READING.

Stator

-
-

Ignition coil

-
-
-
Ignition static parameters measurement with peak voltage adapter.
Measurement conditions:
-
-
-
-
Check pulse transmitter / charge coil on output signal - unipolar connector
(1):
-
-
ENGINE
Correct gearbox oil level.
Disconnect stator connector and, using a digital multimeter, measure stator
resistance.
Resistance shall be 500 Ω ± 40 Ω at 20°C.
There is no need to remove stator to make this reading.
Undo spark plug cap.
Measure coil secondary side resistance between high voltage cable and
ignition coil ground.
Resistance shall be 2250 Ω ± 250 Ω at 20°C.
cold engine
saddle and tank removed from bike
all coupling contacts and ground connections without any corrosion.
for each measurement, strongly press kick start pedal all the way down at
least 5 times.
Position peak voltage adapter R red pushrod onto connector, S black pushrod
to ground, and connector 1 disconnected from ignition coil (2):
reading on the multimeter: 270 volt ± 10 volt
same measurement, but with connector (1) connected to ignition voltage:
reading on the multimeter: 270 volt ± 10 volt.
F.25
REMEDY