Rear Shock Absorber Removal; Chassis - Husqvarna CR 50 / 2011 Workshop Manual

1
H02134
6 2
H02133
3
H02132
6 5
6 4
6
H02130
REAR SUSPENSION

Rear shock absorber removal

- Remove the side panels as described in the relevant paragraph.
- Using two 14 mm ring wrenches, loosen nuts (1) on shock absorber pins,
leaving these latter in their seat.
6 1
- Slightly lift rear wheel, and remove lower pin (2).
- Remove upper pin (3), and shock absorber (4).
6 4
Upon reassembly, position spacer (5) again onto upper pint between
shock absorber (4) and chassis (6).
Upon reassembly, insert upper pin (3) from the right to the left, and the
lower pin (2) from the left to the right.
J.4
H02135
H02131
Ed. 01-09-2010