Disassembling And Servicing The Swinging Arm; Brakes - Husqvarna CR 50 / 2011 Workshop Manual

2
A
3
B
Ed. 01-09-2010
REAR SUSPENSION

Disassembling and servicing the swinging arm

- Set a stand or a block under the engine and see that the rear wheel is lifted
from the ground.
- Remove the secondary drive chain (1) and detach the rear brake line (2) from
the swinging arm (A).
1
H02137
H02144
- Remove the wheel axle nut (3) and the wheel axle (B). There is no need to
loosen the chain tensioners (4) on the swinging arm; in this way, the chain
tension will remain unchanged after reassembly.
- Remove the complete wheel (C).
- Remove shock absorber lower shaft (5).
H02138
C
H02139
J.5
5
H02140