Table of Contents
Advertisement
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660 .
1 .
Select a location to install the Signal Booster that is away from excessive
heat, direct sunlight, moisture and has proper ventilation . Do not place the
Signal Booster in an air-tight enclosure .
2 .
Select a location on the roof of the building to install the Outside Antenna .
Use a cell phone in test mode to find the strongest signal from the cell
tower (see page 6) . Visit www.WilsonElectronics.com to find test mode
function for your particular cell phone .
3 .
Run the Outside Antenna cable to the Signal Booster and attach it to
the connector labeled "Outside Antenna" on the Signal Booster . Run the
Inside Antenna cable to the Signal Booster and attach it to the connector
labeled "Inside Antenna" on the Signal Booster . For more information on
running cable (see page 7) . Lightning Surge Protection is recommended
for all in-building installations (see page 6) .
4 .
Select a location for the Inside Antenna, preferably in the center of
where the signal needs to be amplified . A minimum separation distance
of 20 vertical (within the null zone) or 50 horizontal feet is necessary
for proper operation . If the inside coverage is not sufficient you may
need to increase the separation distance even further (see installation
diagram on pages 3 & 4) .
5 .
Before powering up the Signal Booster, verify that both the Outside
Antenna and the Inside Antenna are connected and check that all
connections are tight . Note: Be careful when plugging the connectors
in so as not to bend the center pins on the connectors (see page 9) .
6 .
The Signal Booster has been packaged with the gain control knobs
adjusted to the highest gain position . If any of the lights are not green,
please refer to pages 10-12 .
Warning: Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster .
IMPORTANT NOTICE
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
•
It is very important to power your Signal Booster using a
surge protected AC Power Strip with at least a 1000 Joule
rating.
•
Failure to do this will void your warranty in the
power surge or lightning strike .
event of a
2
Advertisement
Table of Contents
