Installing A Wilson Electronics Signal Booster; Powering Up A Wilson Electronics Signal Booster - Wilson Electronics Tri-Band 4G-C Installation Manual

Signal booster
Table of Contents

Advertisement

Installing a Wilson Electronics Signal Booster

Select a location to install the Signal Booster that is away from excessive
heat, direct sunlight, moisture and that has proper ventilation . Do not
place the Signal Booster in an air-tight enclosure . Recommended
installation locations for in-building Signal Boosters are near a power
outlet and in a closet or on a shelf .
Note: It is important to have adequate air ventilation. Maintain at least 6
inches of clearance from surrounding objects. Be careful when
plugging the connector in so as not to damage the center pins on
the connectors.
Run the Outside Antenna cable to the Signal Booster and attach it to
the connector labeled "Outside Antenna" on the Signal Booster . Run the
Inside Antenna cable to the Signal Booster and attach it to the connector
labeled "Inside Antenna" on the Signal Booster .
Note: For distances of 20 feet or more, use Wilson low loss cable.
Powering up a Wilson Electronics
Signal Booster
1 . Never point the front of a Directional Outside Antenna toward the Inside
Antenna . See Figures 1 & 2 on page 10 .
2 . Ensure that both the Outside Antenna cable and the Inside Antenna cable
are connected to the Signal Booster and the connections are tight
before powering up the Signal Booster .
3 . Plug the power supply into the Signal Booster input marked "6V DC"
(carefully, to avoid damaging the center pin) . Note: It is very important to
power your Signal Booster using a surge protected AC Power Strip with at
least a 1000 Joule rating. Failure to do this will void your warranty in the
event of a power surge or lightning strike.
4 . If the Signal Booster does not have a green light(s), refer to pages
10-12 .
5 . Using multiple Signal Boosters in one installation could cause interference
to the cell tower (except for the In-Line Signal Booster) .
6 . Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email tech@wilsonelectronics .com . Technical Support
hours are 7 am to 6 pm MST .
9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.

Advertisement

Table of Contents
loading

Table of Contents