Table of Contents
Advertisement
Warning:
Lightning protection is recommended for all installations
(sold separately part #859902) . Take extreme care to
ensure that neither you nor the antenna comes near any
electric power lines .
Installing Lightning Protection
(sold separately)
Install the Lightning Surge
Protector (LSP) close to the Signal
Booster . Attach the cable from
the Outside Antenna to the surge
protector, using a short length of low
loss cable; attach one end to the
LSP and the other to the Outside
Antenna connector on the Signal
Booster . Ensure the LSP is properly
grounded (ground wire not included) .
Visit www.WilsonElectronics.com
or contact Wilson Electronics Sales
Team at 800-204-4104 .
Selecting a Direction for the Outside Antenna
Select a location on the roof of the building to install the Outside Antenna . Use
a cell phone in test mode to find the strongest signal from the cell tower (see
below for more information) . To get the strongest signal possible, it is very
important to set up your Outside Antenna properly . The Inside and the Outside
Antenna must be mounted in such a way that they are able to pick up the best
possible cell signal on the outside of the building and provide the best possible
signal on the inside of the building . Mount the Outside Antenna as high as
possible facing the cell tower in an area with the best possible signal coverage .
Note: Never point the front of a Directional Antenna toward the Inside
Antenna. See Figures 1 & 2 on page 10.
Finding the Strongest Signal
When installing your Signal Booster's Outside Antenna, aiming it towards
the best signal source from you service provider is important . The best way
of getting the strongest signal is to have one person on the roof to rotate
the Outside Antenna, which is connected to the Signal Booster . Turning the
Outside Antenna about 45 degrees at a time, while the second person is
watching the signal strength on the phone inside the building . This allows
you to read the signal strength from the cell tower . It is preferable to have
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Lightning
Surge Protector
(sold separately)
To Inside
Antenna
Signal Booster
Surge Protector
Power Strip recommended for all AC power supplies
To Outside
Antenna
Ground Wire
(not included)
To Signal Booster
6
Advertisement
Table of Contents
