Table of Contents
Advertisement
will not be able to get maximum gain from the booster .
*Note: If the antennas cannot be sufficiently separated, the booster will
have to operate with reduced performance by decreasing the
Gain until a green light is obtained.
4. SOLID GREEN
The indicator lights on the Signal Booster will be a solid green after
the first 15 minute installation period, if the unit is powered up and
working properly .
Warnings and Recommendations
Warning: The Directional Antenna must always be located so the
back or side points to the Inside Antenna . Never point the
front of the Outside Antenna toward the Inside Antenna –
this is to prevent oscillation .
Warning: Connecting the Signal Booster directly to the cell phone with
use of an adapter will damage the cell phone .
Warning: Use only the power supply provided . Use of a non-Wilson
Electronics product may damage your equipment .
Warning: RF Safety: All Inside Antennas used with this Signal
Booster may not have gain (less cable loss) that exceeds
10 .1 dBi and must be located at least 8 inches from all
people . Outside fixed antennas may not have gain that
exceeds -0 .46 dBi (less cable loss) and must be located
least 41 inches from all people . The Outside Antenna
must be connected with a minimum of 40' of RG58
coaxial cable . All antennas shown on page 1 meet these
requirements .
Warning: Verify that both the Outside Antenna and the Inside
Antenna are connected to the Signal Booster before
powering up the Signal Booster .
Recommendation: Lightning Surge Protection is recommended
This device complies with Part 15 of FCC rules . Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation . Changes or modifications not expressly
approved by Wilson Electronics could void the authority to operate this
equipment .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
for all in-building installations.
12
Advertisement
Table of Contents
