Table of Contents
Advertisement
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics
Technical Support Team with any questions at 866-294-1660 .
1 .
Select a location to install the Signal Booster that is away
from excessive heat, direct sunlight, moisture and has proper
ventilation . Do not place the Signal Booster in an air-tight
enclosure .
2 .
Select a location on the roof of the building to install the Outside
Antenna . Use a cell phone in test mode to find the strongest
signal from the cell tower . Visit www.WilsonElectronics.com
to find test mode function for your particular cell phone (see
page 11) .
3 .
Run the Outside Antenna cable to the Signal Booster and
attach it to the connector labeled "Outside Antenna" on the
Signal Booster . Run the Inside Antenna cable to the Signal
Booster and attach it to the connector labeled "Inside Antenna"
on the Signal Booster (see page 7 for more information on
running cable) . Lightning Surge Protection is recommended for
all in-building installations (see page 6) .
4 .
Select a location for the Inside Antenna, preferably in the
center of where the signal needs to be amplified . A minimum
separation distance (combined vertical/horizontal) of 20 feet is
necessary for operation (see page 8) . If the inside coverage is
not sufficient you may need as much as 50 feet of separation .
See installation diagram on pages 3 & 4 .
5 .
Before powering up the Signal Booster, verify that both the
Outside Antenna and the Inside Antenna are connected and
check that all connections are tight . Note: Be careful when
plugging the connectors in so as not to bend the center pins
on the connectors.
6 .
The Signal Booster has been packaged with the gain control
knobs adjusted to the highest gain position . If the light is not
green, please refer to pages 13 & 14 .
7.
Warning:
Connecting the Signal Booster directly to a cell phone
with use of an adapter may damage the cell phone and the
Signal Booster .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
2
Advertisement
Table of Contents
