Table of Contents
Advertisement
Quick Install Overview
See Installation Diagram on pages 3 & 4 . Contact Wilson Electronics
Technical Support Team with any questions at 866-294-1660 .
1 .
Select a location to install the Signal Booster that is away from
excessive heat, direct sunlight, moisture and has proper ventilation . Do
not place the Signal Booster in an air-tight enclosure .
2 .
Select a location on the roof of the building to install the Outside Antenna .
Use a cell phone in test mode to find the strongest signal from the cell tower .
Refer to page 5 . Visit www.WilsonElectronics.com to find the test mode
function for your particular cell phone .
3 .
Run the Outside Antenna cable to the Signal Booster and attach it to
the connector labeled "Outside Antenna" on the Signal Booster . Run the
Inside Antenna cable to the Signal Booster and attach it to the connector
labeled "Inside Antenna" on the Signal Booster . Refer to page 8 for more
information on running cable . Lightning Surge Protection is recommended
for all in-building installations refer to page 7 .
4 .
Select a location for the Inside Antenna, preferably in the center of
where the signal needs to be amplified . A minimum separation distance
of 20 vertical feet (within the null zone) or 50 horizontal feet is
necessary for proper operation . If the inside coverage is not sufficient
you may need as much as 75 feet of horizontal separation (refer to
installation diagram on pages 3 & 4) .
5 .
Before powering up the Signal Booster, verify that both the Outside
Antenna and the Inside Antenna are connected and check that all
connections are tight . Refer to page 9 . Note: Be careful when plugging
the connectors in so as not to bend the center pins on the connectors.
6 .
Press yellow "CH Select" button to desired setting . Your channel will
show on the LCD screen . Refer to pages 10-14 .
7 .
The Signal Booster has been packaged with the gain control knobs
adjusted to the highest gain position . If light is not green, please refer to
pages 10-14 .
Warning: Connecting the Signal Booster directly to a cell phone with
use of an adapter will damage the cell phone and/or the
Signal Booster .
IMPORTANT NOTICE
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
•
It is very important to power your Signal Booster using a
surge protected AC Power Strip with at least a 1000 Joule
rating.
•
Failure to do this will void your warranty in the
power surge or lightning strike .
Mon.- Fri. Hours: 7 am to 6 pm MST.
event of a
2
Advertisement
Table of Contents
