Quick Installation Overview; Quick Install Overview - Wilson Electronics AG Pro 75 Installation Manual

Hide thumbs Also See for AG Pro 75:
Table of Contents

Advertisement

Quick Install Overview

See Installation Diagram on page 3 . Contact Wilson Electronics
Technical Support Team with any questions at 800-204-4104 .
1 .
Select a location to install the signal booster that is away from
excessive heat, direct sunlight, moisture and has proper ventila-
tion . Do not place the signal booster in an air-tight enclosure .
2 .
Select a location on the roof of the building to install the outside
antenna . Use a cell phone in test mode to find the strongest signal
from the cell tower . Visit www .wpsantennas.com to find test
mode function for your particular cell phone . See page 6 .
3 .
Select a location for the inside antenna, preferably in the
center of where the signal needs to be amplified . Separation
distance between inside and outside antennas must be a mini-
mum of 20 vertical feet if installed like "Installation Diagram" on
page 3 . For maximum gain you will need as much as 50 feet of
separation .
4 .
Run the outside antenna cable to the signal booster and at-
tach it to the connector labeled "outside antenna" on the signal
booster . Run the inside antenna cable to the signal booster
and attach it to the connector labeled "inside antenna" on the
signal booster . Note: Be careful when plugging the connectors
in so as not to bend the center pins on the connectors. See
page 8 for more information .
5 .
Before powering up the signal booster, verify that both the
outside antenna and the inside antenna are connected and
check that all connections are tight . Lightning surge protection
is recommended for all in-building installations . See page 7 .
6 .
The AG Pro 75™ Signal Booster has been packaged with the
gain control knobs adjusted to the highest gain position . If one
or both of the lights are red please refer to page 14 .
7.
Warning:
Connecting the signal booster directly to a cell phone
with use of an adapter will damage the cell phone and the
signal booster .
Contact Wilson Electronics Technical Support Team with any questions at
or email:
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents