Quick Install Overview - Wilson Electronics AG Pro Quint 461104 Installation Manual

Quick Install Overview

See Installation Diagram on page 3 . Contact Wilson Electronics Technical Support
Team with any questions at 866-294-1660
1 . Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight, moisture and has proper ventilation . Do not place the Signal
Booster in an air-tight enclosure .
2 . Select a location on the roof of the building to install the Outside Antenna . Use
a cell phone in test mode to find the strongest signal from the cell tower (refer to
page 7 & 8) . Visit www.WilsonElectronics.com to find test mode function for your
particular cell phone .
3 . Run the Outside Antenna cable to the Signal Booster and attach it to the
connector labeled "Outside Antenna" on the Signal Booster . Run the Inside
Antenna cable to the Signal Booster and attach it to the connector labeled
"Inside Antenna" on the Signal Booster . For more information on running cable
(refer to page 8) . Lightning Surge Protection is recommended for all in-building
installations (refer to page 7) .
4 . Select a location for the Inside Antenna, preferably in the center of where the
signal needs to be amplified . A minimum separation distance of 20 vertical feet
(within the null zone) or 50 horizontal feet is necessary for proper operation .
If the inside coverage is not sufficient you may need as much as 75 feet of
horizontal separation (refer to installation diagram on pages 3 & 4) .
5 . Before powering up the Signal Booster, verify that both the Outside Antenna
and the Inside Antenna are connected and check that all connections are tight .
Note: Be careful when plugging the connectors in so as not to bend the center
pins on the connectors .
6 . The Signal Booster has been packaged with the gain control knobs adjusted
to the highest gain position . If any of the lights are not green, please refer to
pages 11 & 12 for troubleshooting lights .
IMPORTANT NOTICE
5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Mon . - Fri . hours: 7am to 6pm MST .
• It is very important to power your Signal Booster using a
surge protected AC Power Strip with at least a 1000 Joule
rating.
• Failure to do this will void your warranty in the event of a
power surge or lightning strike .
Mon.- Fri. Hours: 7 am to 6 pm MST.