Table of Contents
Advertisement
Warnings and Recommendations
Warning: The Outside Antenna must always be located so the back
or side points to the Inside Antenna . Never point the front
of the Outside Antenna toward the Inside Antenna – this is
to prevent oscillation .
Warning: Connecting the Signal Booster directly to the cell phone with
use of an adapter will damage the cell phone and/or Signal
Booster .
Warning: Use only the correct Wilson Electronics power supply . Use
of a non-Wilson Electronics product may damage your
equipment .
Warning: RF Safety: FCC regulations require that any fixed Outside
Antenna used with this Signal Booster may not have gain
(less cable loss) that exceeds 15 dBi gain and must be
located at least 21 inches from all people . Inside Antennas
must not exceed 12 .1 dBi gain (less cable loss) and must
be located at least 8 inches from all people .
Warning: Verify that both the Outside Antenna and the Inside
Antenna are connected to the Signal Booster before
powering up the Signal Booster .
Recommendation: Omni Directional Antennas are not recommended with
Recommendation: Lightning Surge Protection is recommended for all in-
This device complies with Part 15 of FCC rules . Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation . Changes or modifications not expressly
approved by Wilson Electronics could void the authority to operate this
equipment .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
this Signal Booster .
building installations .
Mon.- Fri. Hours: 7 am to 6 pm MST.
16
Advertisement
Table of Contents
