Table of Contents
Advertisement
Lights and Troubleshooting
Green:
If the indicator lights on the Signal Booster are green, the unit is powered up and working
properly .
Red:
If one or more lights on the Signal Booster are red, this indicates that the Signal Booster
has shut down on that frequency to prevent an oscillation (feedback) . First, make sure that
all connections are tight . The Outside Antenna needs to be moved farther from the Inside
Antenna . Move the Outside Antenna on the roof of the car to the rear of the car, but at least
8-12 inches from the rear or side windows . Reset the Signal Booster by disconnecting then
reconnecting the power to the signal booster .
Blinking
If one or more of the lights on the Signal Booster are blinking red, this means that the Signal
Red:
Booster has shutoff due to close proximity to the handset or mobile device . Increase the
distance between the handset and the Inside Antenna until the light is no longer flashing red .
Contact Wilson Electronics Technical Support Team for assistance .
Warnings and Recommendations
Warning:
In a wireless installation, do not plug the Signal Booster directly into the cell phone or
cellular data card using an antenna adapter . It will damage the Signal Booster, cell
phone or cellular data card .
Warning:
Do not plug in the DC power supply until the Outside and Inside Antenna cables are
attached to the Signal Booster .
Warning:
The Inside Antennas must have 18 inches of separation distance from all active users .
Warning:
RF Safety: Any antenna used with this device must be located at least 8 inches from
all persons and can be found on page 1 of the Install Guide .
Warning:
Use only the power supply provided in this package . The power supply must be 6 V DC
Output .
Warning:
The Outside Antenna must be installed no higher than 10 meters (32'9") above ground .
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider's consent. Most wireless providers consent to the use of signal boosters. Some
providers may not consent to the use of this device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved antennas and cables as specified by the
manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served
by using this device .
This device complies with Part 15 of FCC rules . Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modifications not expressly
approved by Wilson Electronics could void the authority to operate this equipment .
Contact Wilson Electronics's Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
Mon.- Fri. Hours: 7am to 6 pm MST.
4
Hide quick links:
Advertisement
Table of Contents
