Table of Contents
Advertisement
Warnings and Recommendations
Warning: The Outside Antenna must always be located so the back
or side points to the Inside Antenna . Never point the front
of the Outside Antenna toward the Inside Antenna – this is
to prevent oscillation .
Warning: Connecting the Signal Booster directly to the cell phone with
use of an adapter will damage the cell phone .
Warning: Use only the correct Wilson Electronics power supply . Use
of a non-Wilson Electronics product may damage your
equipment .
Warning: RF Safety for 807180: FCC regulations require that any
fixed Outside Antenna used with this Signal Booster may
not have gain (including cable & connector losses) that
exceeds 15 dBi and must be located at least 27 inches
from all people . Inside Antennas must not exceed 4 .1 dBi
gain (including cable & connector losses) and must be
located at least 8 inches from all people . The antennas
shown on page 1 meet these requirements .
Warning: RF Safety for 807380: FCC regulations require that any
fixed Outside Antenna used with this Signal Booster may
not have gain (less cable loss) that exceeds 15 dBi and
must be located at least 22 inches from all people . Inside
Antennas must not exceed 6 dBi gain (less cable loss) and
must be located at least 8 inches from all people . When
using the Inside Panel Antenna on page 1, the antenna
must be connected with at least 22 feet of RG-58 coaxial
cable . All antennas on page 1 meet these requirements .
Warning: Verify that both the Outside Antenna and the Inside
Antenna are connected to the Signal Booster before
powering up the Signal Booster .
Recommendation: Omni directional antennas are not recommended with
Recommendation: Lightning surge protection is recommended for all in-
This device complies with Part 15 of FCC rules . Operation is subject to two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation . Changes
or modifications not expressly approved by Wilson Electronics could void the authority to
operate this equipment .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
this Signal Booster .
building installations .
Mon.- Fri. Hours: 7 am to 6 pm MST.
16
Advertisement
Table of Contents
