Installing The Low-Profile Antenna; Installing A Wilson Electronics Signal Booster - Wilson Electronics 271201 Installation Manual

Table of Contents

Advertisement

Installing the Low-Profile Antenna

Signal Booster
3
Contact Wilson Electronics's Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
Warning: Do not install the low-profile
!
antenna within four inches of metal .
(Metal found inside the vehicle's seat will
not affect the antenna's performance .)
Low-profile
Antenna
Warning: Do not plug in the DC power
!
supply until the outside and inside antenna
cables are attached to the Signal Booster .
Place the Low-Profile Antenna on the
side of the driver's seat for maximum
performance .
Install the Low-Profile Antenna at least eight
inches, but not more than 12 inches, from
where the cellular device will be used .
Install the Low-Profile Antenna at the same
angle as the cell phone when held in use, or
place next to the laptop's cellular data card .
This will maximize the signal strength .
For a more professional looking installation,
the Low-Profile Antenna may be slid under
the seat cover or upholstery, high on the
driver's seat .
Warning: The inside antenna must be
!
installed with a separation of at least eight
inches from all persons and must not
be located in conjunction with any other
antenna or Signal Booster .
Run the cable from the outside antenna and
attach it to the connector labeled "Outside
Antenna" on the Signal Booster .
Attach the Low-Profile Antenna cable to the
connector labeled "Inside Antenna" on the
Signal Booster .
Hours: 7am to 6 pm MST.

Advertisement

Table of Contents
loading

This manual is also suitable for:

271701

Table of Contents