Table of Contents
Advertisement
Installing a Wilson Electronics Signal Booster
Select a location to install the signal booster that is away from
excessive heat, direct sunlight, moisture and that has proper
ventilation . Do not place the signal booster in an air-tight
enclosure .
Recommended installation locations for in-building signal boosters
are:
• On a shelf
• In a closet
• Near a power outlet
Note: It is important to have adequate air ventilation. Maintain at
least 6 inches of clearance from surrounding objects.
Run the outside antenna cable to the signal booster and attach it
to the connector labeled "outside antenna" on the signal booster .
Run the inside antenna cable to the signal booster and attach it to
the connector labeled "inside antenna" on the signal booster . Note:
For distances of 20 feet or more, use Wilson 400 low loss coax cable
to prevent significant signal loss.
Note: Be careful when plugging
the connector in so as not to
damage the center pins on the
connectors.
Warning: An inside
antenna must have a
separation distance from
all persons that is at least
15 inches for the panel
antenna .
Contact Wilson Electronics Technical Support Team with any questions at
or email:
10
Hide quick links:
Advertisement
Table of Contents
