Installing The Inside Antenna; Installing A Wilson Electronics Signal Booster - Wilson Electronics AG Pro Quint 461104 Installation Manual

After drilling the required hole, run the cable through and seal it with cable
bushings, silicone or other waterproof sealant to enclose the hole that you have
created . In some instances, it may be possible to run the cable up into the fascia of
the attic overhang . In this circumstance, the cable will be accessible in the attic for
further routing .

Installing the Inside Antenna

Select a location for the Inside Antenna, preferably in the center of where the signal
needs to be amplified . A minimum separation distance of 20 vertical feet (within
the null zone) or 50 horizontal feet is necessary for proper operation . If the
inside coverage is not sufficient you may need as much as 75 feet of horizontal
separation . Refer to installation diagram on pages 3 & 4 .
Ceiling
Rafters
In some cases, multiple Inside Antennas may be required, for instance if you
have multiple rooms with poor signal . A signal is split by using a splitter . Visit
www.WilsonElectronics.com or call 800-204-4104 to purchase additional cable(s)
and antenna(s) .

Installing a Wilson Electronics Signal Booster

Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight, moisture and that has proper ventilation . Do not place the Signal
Booster in an air-tight enclosure . Recommended installation locations for in-
building Signal Boosters are near a power outlet and in a closet or on a shelf .
Note: It is important to have adequate air ventilation. Maintain at least 6
inches of clearance from surrounding objects. Be careful when
plugging the connector in so as not to damage the center pins on
the connectors.
Run the Outside Antenna cable to the Signal Booster and attach it to the connector
labeled "Outside Antenna" on the Signal Booster . Run the Inside Antenna cable to
the Signal Booster and attach it to the connector labeled "Inside Antenna" on the
Signal Booster .
9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Inside
Antenna
Mon.- Fri. Hours: 7 am to 6 pm MST.
Ceiling
Drywall