Remove The Part From The Printer - 3D Systems ProJet 1200 User Manual

6 . Select File > Submit Job .
NOTE: A dialogue box will appear instructing you to install the
print platform and print cartridge . Once ready, select OK . You will
be prompted to save the file.
Browse to the location where you intend to save the file and select Save .
7 .
NOTE: Enter the file name in the file name field and ensure
Build Files (* .vbf)
NOTE: A progress indicator will appear as the part is processed .
NOTE: Once the part has been processed, it will begin printing .
NOTE: The printer LCD will display how much time remains before
the print has been completed . You may also go to
Status to determine the estimated print time .
8 . Once printing has finished, the printer display will indicate that printing has completed.

REMOVE THE PART FROM THE PRINTER

After the part has been printed, it must be processed . Refer to the following steps to complete post processing of the part . You will need
a towel to catch resin that may drip from the part as well as two containers of 70% alcohol large enough to completely submerge the
part. It is important to limit the exposure of the material cartridge to light.
Always wear protective gloves during post process .
CAUTION: Always follow the precautions noted on the MSDS sheets for any chemical being used .
1 . Place a towel under the part . Rotate the print platform clamp lever up enough
to unlock the print platform .
NOTE: Resin may drip from the part . The towel is used to collect
dripping resin so that printer parts are not exposed to resin .
3D Systems, Inc.
as the Save as type is selected
PJP3P
File > Build
31