Table of Contents
Advertisement
CURE AND POST PROCESS THE PART
1 .
After the part is completely dry, insert the print platform onto the curing
chamber carousel .
2 .
The curing chamber carousel has metal tabs on top that secure the print
platform . Slide the print platform under the tabs .
3 .
Close and latch the curing chamber door .
Select
File > Post Curing >
4 .
Curing the part will take approximately 10 minutes. Do not open the curing
5 .
chamber door until the curing process has been completed .
Once the part has been cured, remove the print platform from the curing
6 .
chamber carousel .
Using a blade, carefully scrape the part off the print platform .
7 .
8 .
Use your fingers, remove the base from the part.
Use fine grit sandpaper to sand down the unwanted protrusions from the
9 .
bottom of the part .
Apply Isopropyl alcohol to a soft cloth and gently clean the part .
10 .
3D Systems, Inc.
Start .
35
Advertisement
Table of Contents
