REMOVE THE PART FROM THE PRINTER
After the part has been printed, it must be processed . Refer to the following steps to complete post processing of the part . You will need
a towel to catch resin that may drip from the part as well as two containers of 70% alcohol large enough to completely submerge the
part. It is important to limit the exposure of the material cartridge to light.
Always wear protective gloves during post process .
CAUTION: Always follow the precautions noted on the MSDS sheets for any chemical being used .
1 .
Place a towel under the part . Rotate the print platform clamp lever up enough
to unlock the print platform .
NOTE: Resin may drip from the part . The towel is used to collect
dripping resin so that printer parts are not exposed to resin .
2 .
Pull the print platform handle (A) out from under the clamp .
NOTE: The part will hang down under the print platform .
3D Systems, Inc.
A
32