Table of Contents
Advertisement
4 .
Remove the peripherals box (A) and the upper foam insert (B).
5 .
Carefully remove the printer from the lower boxed foam support and place it on
a solid, level base where it will be used .
CAUTION: Do not install the printer near direct sunlight . If the
material cartridge is exposed to direct sunlight, the resin will begin
to cure .
NOTE: There should be a utility power outlet and an active network
port nearby .
NOTE: There should be a minimum of 6"/152 mm air space between
the back of the printer and any other object .
NOTE: There should be at least 10"/254 mm air space on either side
of the printer .
6 .
Remove the protective film (A) covering the display.
3D Systems, Inc.
B
A
12
A
Advertisement
Table of Contents
