Step 8: Installing The Supplied Microphone And Hood With Lens Cover - Sony HVR-A1J Service Manual

Step 8: Installing the supplied microphone and
hood with lens cover
Installing the supplied
microphone
Install the supplied XLR adaptor and
microphone. You can receive the desired
audio quality.
1
Attach the XLR adaptor  to the
accessory shoe on the camcorder
and tighten the screw of the XLR
adaptor.
2
Connect the plug of the XLR
adaptor to the Active Interface
Shoe  of the camcorder.
3
Attach the wind screen  to the
microphone .
4
Loosen the microphone holder
 screw and open the cover.
5
Place the microphone into the
holder with the model name
(ECM-NV1) facing upward, close
the cover, and tighten the screw.
6
Connect the plug of the
microphone to the INPUT1
connector .
7
Set the INPUT LEVEL selector to
MIC or MIC ATT.
When the selector is set to MIC ATT,
you can reduce the volume by about
20dB.
Set the +48V switch to ON.
19
Continued 