Page 1
How to use How to use Australian Model Acrobat Reader Acrobat Reader Chinese Model Hong Kong Model Korea Model Japanese Model N MECHANISM (MDX-N110) Photo: HDR-FX7 Link Link SPECIFICATIONS DISASSEMBLY SCHEMATIC DIAGRAMS MODEL INFORMATION TABLE BLOCK DIAGRAMS PRINTED WIRING BOARDS SERVICE NOTE...
Rotary heads, MPEG-1 Audio Layer -2, batterypack NP-F570 The unique pixel array of Sony's ClearVid Quantization: 16 bits (Fs 48 kHz, stereo) CMOS Sensor and image processing system Mass (approx.) transfer rate: 384 kbps (new Enhanced Imaging Processor) allows 1.4 kg (3 lb 2 oz) main unit only 1.6 kg...
Page 3
2.2 k COMPONE D1/D3 4.5mm 1/4 3CMOS NT OUT Y 1Vp-p 75 350mV 75 1440 810 HDV/ HDMI OUT A 19 DV 16 9 16 9 LANC ø 2.5 mini-B 16 9 HDV/DV i.LINK IEEE1394 4 S100 HDR-FX7/FX7E_L2 — 3 —...
Page 4
Model information table Model HDR-FX7 HDR-FX7E AEP, UK, E, AUS, Destination US, CND, E, KR, J CH, HK Color system NTSC • Abbreviation AR : Argentine model AUS : Australian model BR : Brazilian model CH : Chinese model CND : Canadian model...
Page 5
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU PUBLISHED BY SONY.
Page 6
ENGLISH JAPANESE ENGLISH JAPANESE • • • • • • • • HDR-FX7/FX7E_L2 — 6 —...
1) Select page: 0, address: 01, and set data:01. 2) Select page: A, address: 10, set data:00 and press the “PAUSE (Write) ” button of the adjustment remote commander. 3) Select page: 0, address: 01, and set data: 00. HDR-FX7/FX7E_L2...
C : Corrected by customer Refer to “1-5-3. Self-diagnosis Code Table”. Indicates the appropriate H : Corrected by dealer step to be taken. E : Corrected by service E.g. engineer 31 ..Reload the tape. 32 ..Turn on power again. HDR-FX7/FX7E_L2...
Page 10
If it does not recover, inspect the focus MR sensor of lens block (Cannot initialize focus.) (Pin wl, ea of CN5802 on the YY-003 board). If not faulty, inspect the focus motor drive circuit (IC6004 on the YY-003 board). HDR-FX7/FX7E_L2...
YY-003 BOARD (SIDE A) about 330 msec Note: The length of low section will vary a little depending on the conditions. Fig. 2 Change in output voltage of R6233 IC6203 R6233 Fig. 1 Measurement points on the YY-003 board HDR-FX7/FX7E_L2...
Page 12
“Optical Axis Adjustment” and “Angular Velocity Sensor Sensitivity Adjustment”. Note 2: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ. After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation. HDR-FX7/FX7E_L2...
Page 13
00, and then retry. Note 2: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ. After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation. HDR-FX7/FX7E_L2...
Page 14
00, and then retry. Note 2: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ. After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation. HDR-FX7/FX7E_L2...
Page 15
ENGLISH JAPANESE ENGLISH JAPANESE 1. SERVICE NOTE HDR-FX7/FX7E_L2...
Page 16
ENGLISH JAPANESE ENGLISH JAPANESE CPC-7 (J-6082-382-A) TT-003 BOARD (SIDE B) C : 3 1 : 1 1 HDR-FX7/FX7E_L2...
Page 17
ENGLISH JAPANESE ENGLISH JAPANESE wl ea HDR-FX7/FX7E_L2 1-10...
Page 18
ENGLISH JAPANESE ENGLISH JAPANESE ed eg YY-003 BOARD (SIDE A) IC6203 R6233 HDR-FX7/FX7E_L2 1-11...
Page 19
ENGLISH JAPANESE ENGLISH JAPANESE HDR-FX7/FX7E_L2 1-12...
Page 20
ENGLISH JAPANESE ENGLISH JAPANESE HDR-FX7/FX7E_L2 1-13...
Page 21
ENGLISH JAPANESE ENGLISH JAPANESE HDR-FX7/FX7E_L2 1-14E...
It is possible that a wire is snapped. NOTE FOR DISCONNECTING THE HARNESS (COAXIAL CABLE) When disconnecting the harness (coaxial cable), do not pull the harness part but pull off the connector body with tweezers etc. Harness (coaxial cable) Tweezers etc. HDR-FX7/FX7E_L2...
Note: Avoid Flexible Board from the Lens Unit when you install 2 Remove three screws for connection. the Lens Unit. Flexible Board Three Screws Avoid Flexible Board Do not damage from the Lens Unit. Flexible Board. Ring Unit Lens Unit HDR-FX7/FX7E_L2 2-9E...
Page 31
Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown. Flexible Board of the Switch Block Control comes in front of the CF Retainer Plate. Loud Speaker Harness arrangement Tape (A) RR-003 Board Claw Hook CF Retainer Plate FP-487 Flexible Board Hook Interception Plate (CMOS) Harness arrangement HDR-FX7/FX7E_L2 HELP...
CONTROL SWITCH BLOCK (CK18500) (GG-OO CONNECTION) MM-061 BOARD(NOISE CANCELER) CONTROL SWITCH BLOCK (PL18500) FP-481 FLEXIBLE BOARD CONTROL SWITCH BLOCK (PS18500) (REMOTE SENSOR (FRONT)) FP-031, FP-032, FP-228 FLEXIBLE BOARD FP-498 FLEXIBLE BOARD (MECHANISM BLOCK) (GG-MM CONNECTION) COMMON NOTE FOR SCHEMATIC DIAGRAMS HDR-FX7/FX7E_L2...
Page 48
In addition, ensure that the receiver is not covered with dusts nor exposed to strong light. Les composants identifiés par une marque 0 sont critiques pour la sécurité. Ne les remplacer que par une pièce portant le numéro spécifie. HDR-FX7/FX7E_L2...
Page 49
ENGLISH JAPANESE 4-2. SCHEMATIC DIAGRAMS ENGLISH JAPANESE 4-2. SCHEMATIC DIAGRAMS (JAPANESE) For PTB-450: Pattern box PTB-450 J-6082-200-A J-6020-250-A For PTB-1450: Small pattern box J-6082-559-A PTB-1450 J-6082-557-A L = 1 m (PTB-450) L = 40 cm (PTB-1450) Ω HDR-FX7/FX7E_L2...
Page 51
Schematic diagrams of the TT-003, YY-003, NN-003, HH-003 and GG-003 boards are not shown. Pages from 4-6 to 4-29 are not shown. HDR-FX7/FX7E_L2...
Page 66
: pattern of the rear side (The other layers’ patterns are not indicated) • Through hole is omitted. • There are a few cases that the part printed on diagram isn’t mounted in this model. • C: panel designation (JAPANESE) HDR-FX7/FX7E_L2 4-43...
Page 68
Printed wiring boards of the TT-003, YY-003, NN-003, HH-003 and GG-003 boards are not shown. Pages from 4-46 to 4-52 are not shown. HDR-FX7/FX7E_L2...
Page 81
Mounted parts location of the TT-003, YY-003, NN-003, HH-003 and GG-003 boards are not shown. Pages 4-66 to 4-68 are not shown. HDR-FX7/FX7E_L2...
Page 86
: Argentine model AUS : Australian model : Brazilian model : Chinese model CND : Canadian model : East European model HK : Hong Kong model : Japanese model : Tourist model : Korea model : North European model HDR-FX7/FX7E_L2...
FB5603 1-400-331-11 FERRITE, EMI (SMD) (1005) < IC > < IC > IC101 6-600-163-01 IC RS-770 IC5601 (Not supplied) IMX013BLA-13 (CMOS IMAGER) (Note) Note: Note: Be sure to read “Precautions for Replacement of HDR-FX7/FX7E_L2 Imager” on page 4-3 when changing the imager. 5-17...
Page 104
* CN8304 1-816-654-51 FFC/FPC CONNECTOR (LIF) 6P * CN8001 1-816-654-51 FFC/FPC CONNECTOR (LIF) 6P < IC > < IC > IC8301 6-707-702-01 IC NJM2746RB1 (TE2) IC8302 6-707-702-01 IC NJM2746RB1 (TE2) IC8001 8-759-489-19 IC uPC6756GR-8JG-E2 IC8303 6-707-702-01 IC NJM2746RB1 (TE2) IC8304 6-707-702-01 IC NJM2746RB1 (TE2) HDR-FX7/FX7E_L2 5-21...
Page 105
1-219-602-11 METAL CHIP 0.5% 1/16W R8320 1-219-601-81 METAL CHIP 0.5% 1/16W R8321 1-219-601-81 METAL CHIP 0.5% 1/16W R8322 1-219-602-11 METAL CHIP 0.5% 1/16W Electrical parts list of the NN-003 board is not shown. Pages 5-23 and 5-24 are not shown. HDR-FX7/FX7E_L2 5-22...
Page 107
When mounting these parts, mount new battery holder R9028 1-208-683-11 METAL CHIP 0.5% 1/16W first and attach new lithium battery next. R9029 1-208-695-11 METAL CHIP 3.3K 0.5% 1/16W R9031 1-218-953-11 RES-CHIP 1/16W Note: • Refer to page 5-1 for mark 0. HDR-FX7/FX7E_L2 5-26...
Page 108
< VARISTOR > VDR961 1-801-862-11 VARISTOR, CHIP (1608) VDR962 1-801-862-11 VARISTOR, CHIP (1608) VDR963 1-801-862-11 VARISTOR, CHIP (1608) VDR964 1-801-862-11 VARISTOR, CHIP (1608) Electrical parts list of the TT-003 board is not shown. Pages 5-28 to 5-37 are not shown. HDR-FX7/FX7E_L2 5-27...
Page 112
HARDWARE LIST (1/3) #1: M1.7 X 2.5 #2: M1.7 X 4.0 #3: M1.7 X 2.5 #4: M1.4 X 2.5 (Tapping) (Black) (Black) (Red) (Dark Silver) 2-635-562-11 2-635-562-31 2-660-401-01 3-348-998-81 #5: M1.7 X 3.5 (Tapping) #6: M1.4 X 1.7 #7: M1.7 X 1.6 #8: M1.7 X 3.5 (Tapping) (Black) (Silver)
Page 113
HARDWARE LIST (2/3) #21: M1.4 X 3.0 #22: M1.7 X 5.0 (Tapping) #23: M1.7 X 4.0 (Tapping) #24: B1.7 X 5.5 (Tapping) (Black) (Silver) (Black) (Black) 2-662-396-21 3-083-261-01 3-080-204-11 4-679-805-11 #25: M1.7 X 3.0 #26: M1.4 X 2.0 #27: M1.4 X 2.0 #28: M1.4 X 4.0 (Tapping) (Black) (Silver)
Page 114
HARDWARE LIST (3/3) #41: M3.0 X 8.0 (Tapping) #42: M2.0 X 4.0 (Tapping) #43: M1.7 X 4.0 #44: M1.7 X 3.0 (Tapping) (Silver) (Silver) (Red) (Silver) 3-065-748-01 7-628-253-00 2-660-401-31 3-078-890-61 #45: M1.4 X 2.5 #46: M1.7 X 3.0 #47: M1.4 X 3.0 (Tapping) #48: M1.7 X 2.5 (Silver) (Red)
Page 115
ENGLISH JAPANESE ENGLISH JAPANESE [Description of main button functions on toolbar of the Adobe Acrobat Reader Ver5.0 (for Windows)] Toolbar Printing a text Reversing the screens displayed once • To reverse the previous screens (operation) one by one, click 1. Click the Print button 2.