Rear View - Sony HVR-A1J Service Manual

3-30.Mode Slider Ass'y
1. Removal procedure
1) Remove the capstan cover 1 and remove the extension spring
(pinch limiter) 2.
2) Remove the belt 3 from the conversion gear.
Remove the screw (special head screw M1.4 × 1.4) 4.
3)
4) Remove the EJ lever retainer 5 from the mode slide shaft.
5) Remove the mode slider ass'y 6 from the cam gear shaft in
the direction of the arrow.
Capstan cover
(Align the attaching
position)
When attaching, align the attaching
position using the two position setting
holes and groove.
Dowel
Two holes
Points to be noted
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Apply grease
Cam gear shaft,
Mode slider shaft
Cam gear shaft
Mode slider shaft
HVR-A1J/A1U/A1N/A1E/A1P/A1C
2. Attachment procedure
1)
2)
3)
4)
5)
6)
7)
4 Screw
(M1.4 × 1.4)
6 Mode slider ass'y
Dowel A
Conversion
gear
3 Belt
Cam gear shaft
Mode slider shaft
6 Mode slider ass'y
LS chassis claw
6-102
Apply grease on the cam gear shaft and the mode slider shaft.
Amount of grease: A ball of grease of 1.0 mm diameter.
Engage the shaft B in the groove C and install the mode slider
ass'y 6 while aligning its side D and E engage it in the claw
of the LS chassis, then install the mode slider ass'y 6.
Install the EJ lever retainer 5 while engaging the dowel A.
Install the screw (special head screw M1.4 × 1.4) 4.
Tightening torque: 0.04 ± 0.01 N•m (0.61 ± 0.1 kgf•cm)
Hook the belt 3 on the conversion gear and install it while
rotating the conversion gear.
Install the tension coil spring (pinch limiter) 2 while being
careful of the orientation of the hook.
And attach the capstan cover 1. (Don't re-use the capstan
cover.)
5 Lever EJ retainer
Side face D
Hook must face
2 Extension spring (pinch limitter)
upward.
Side face C
Shaft B
Groove B
Hook must face
downward.

Rear view

1 Capstan cover
Don't re-use
the capstan
cover