Sony HVR-A1J Service Manual page 174

1-2-3. Initialization of F, 63 to 6F Page Data
1. Initializing of F, 63 to 6F Page Data
Note 1: If "Initialization of Pages F, 63 to 6F" is executed, all
data on pages F, 63 to 6F are initialized. (Only an indi-
vidual page cannot be initialized)
Note 2: If the F, 63 to 6F page data has been initialized, the fol-
lowing adjustments need to be performed again.
1) Modification of F, 63 to 6F page data
2) Camera system adjustment
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Adjustment Page
Adjustment Address
Initializing method:
Order Page Address Data Procedure
1 0
2 0
3 6
4 6
5 6
6 6
7
HVR-A1J/A1U/A1N/A1E/A1P/A1C
F
00 to FF
63
00 to FF
64
00 to FF
65
00 to FF
66
00 to FF
67
00 to FF
68
00 to FF
69
00 to FF
6A
00 to FF
6B
00 to FF
6C
00 to FF
6D
00 to FF
6E
00 to FF
6F
10 to FF
01 01
10 00
Set the following data, and
press PAUSE (Write) button.
01
2D: NTSC model
2F: PAL model
03 02 Press PAUSE (Write) button.
Check the data changes to
02
"01".
01 00 Press PAUSE (Write) button.
Perform "Modification of F,
63 to 6F Page Data"
2. Modification of F, 63 to 6F Page Data
If the F, 63 to 6F page data has been initialized, change the data of
the "Fixed data-2" address shown in the following table by manual
input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) If modification of data on pages F, set data: 00 to page: 0,
address: 10, and then select pages F.
3) If modification of data on pages 63 to 6F, set data: 06 to page:
0, address: 10, and then select pages 3 to F.
After the modification of data finished, return the data on page:
0, address: 10 to "00".
4) New data for changing are not shown in the tables because
they are different in destination. When changing the data, copy
the data built in the same model.
Note: If copy the data built in the different model, the
camcorder may not operate.
5) When changing the data, press the PAUSE (Write) button of
the adjustment remote commander each time when setting new
data to write the data in the non-volatile memory.
6) Check that the data at the addresses for adjustment are initial
values (adjustment initial values) listed in the table.
If different, change them to the adjustment initial values.
Processing after Completing Modification F, 63 to 6F page
data:
Order Page Address Data
1 0 10
2 2 00
3 2 01
6-15
Procedure
00
29
29 Press PAUSE (Write) button.