NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, dont' pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, dont' press down at wire of connector.
It is possible that a wire is snapped.
NOTE FOR DISCONNECTING THE HARNESS (COAXIAL CABLE)
Harness (coaxial cable)
HVR-A1J/A1U/A1N/A1E/A1P/A1C
2. DISASSEMBLY
2. DISSASSEMBLY
When disconnecting the harness (coaxial cable), do not pull the
harness part but pull off the connector body with tweezers etc.
Tweezers etc.
2-1
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)