Piper Turbo Saratoga PA-32-301T Pilot's Manual page 91

PIPER AIRCRAFT CORPORATION SECTION 4
PA-32-301T, TURBO SARATOGA NORMAL PROCEDURES
(c)
Starting
Engine When Hot
Open the throttle approximately 1 2 inch. Turn ON the master
and the electric
fuel
pump. Move the mixture control lever to
idle
cut-off
and engage the starter
by rotating the magneto
switch
clockwise. When
the engine
fires,
release
the magneto
switch,
advance the
mixture and
move
the throttle to the desired setting.
(d) Starting Engine When Flooded
The throttle
lever should be full OPEN. Turn ON the
master
switch
and turn OFF the
electric fuel pump. Move the
mixture
control
lever to idle cut-off
and
engage the
starter
by rotating
the
magneto
switch clockwise.
When
the engine
fires, release
the
magneto
switch, advance the mixture and retard
the throttle.
(e)
Starting
Engine With External Power Source
An optional feature
called the Piper External
Power (PEP)
allows the
operator to
use
an
external
battery to crank
the
engine
without
having to gain
access
to the airplane's battery.
Turn the
master
switch OFF and turn all electrical equipment
OFF. Connect the RED lead
of the PEP kit
jumper cable to the
POSITIVE
(+)
terminal of
an
external 12-volt battery
and the
BLACK lead to the NEGATlVE
(-)
terminal.
Insert the plug
of
the
jumper
cable into the socket located on the fuselage.
Note that
when the plug is inserted,
the electrical system is ON. Proceed
with
the normal starting
technique.
ISSUED: JANUARY
10, 1980
REPORT: VB-1070
REVISED: AUGUST 3
1981
4-19