Options Service Check - Lexmark Optra Color 45 Service Manual

4080-001

Options Service Check

Flash Memory Option(s)
Run a copy of the test page and check to see if the option you are
checking is listed. The printer does not recognize the option being
installed if the option is not listed. Check to make sure that the
Memory SIMM is installed correctly and is not broken or damaged. If
the Memory SIMM is correctly installed, and not broken or damaged,
then run the
flash SIMM. If the problem continues, replace the controller board,
refer to the "Controller Board Removal" on page
DRAM Memory Option(s)
This service check is the same as the flash memory option service
check with the following exception:
Run the "DRAM Memory Test" on page 3-5
DRAM Memory SIMM is correctly installed and not broken or
damaged. If the test fails, replace the DRAM SIMM, refer to the
"Memory (SIMM) Card Cover Removal" on page
problem continues, replace the controller board, refer to the
"Controller Board Removal" on page
Hard Disk Option
Be sure the hard disk and the hard disk adapter board are correctly
installed. Run the
Test on the Diagnostic Menu when a problem is suspected either
with the hard disk adapter board or with the hard disk.
Note: The Quick Disk Test is a non-destructive test and indicates
Pass or Fail. If the test fails, replace the hard disk, refer to the
"Option Card(s) Removal" on page
replace the controller board, refer to the
Removal" on page
The "Disk Test/Clean" on page 3-9
if the data is corrupted and unusable. This test is divided into a
cleaning and a verifying section.
Note: The test can be very lengthy and leaves the hard disk
unformatted. The servicer or user must reformat the disk using the
"Flash Test" on page
"Quick Disk Test" on page 3-8
4-20.
3-10. If the test fails, replace the
from the menu if the
4-20.
4-25. If a problem still exists,
"Controller Board
is used to help restore the disk
Diagnostic Information
4-20.
4-7. If the
from the Device
2-13