Idler Pulley Assembly Removal; Left Side Frame Assembly Removal - Lexmark Optra Color 45 Service Manual

4080-001

Idler Pulley Assembly Removal

1. Remove the input / output tray assembly.
2. Remove the front cover, refer to
page 4-3.
3. Move the printhead carrier assembly to the center of the printer.
4. Release the tension on the idler pulley by pressing the idler
pulley toward the transport carrier motor.
5. Remove the carrier belt from the carrier transport motor.
6. Remove the carrier belt from the idler pulley and slide the idler
pulley out of the printer.

Left Side Frame Assembly Removal

1. Remove the input / output tray assembly.
2. Remove all covers, refer to
3. Remove the carrier frame assembly, refer to the
Frame Assembly Removal" on page
4. Remove the two screws securing the small feed roller spring
connector rail and remove the rail, refer to
page 4-10.
5. Remove the two screws securing the star roller assembly and
remove.
6. Remove the gear box assembly, refer to the
Assembly Removal" on page
7. Remove the three screws from the left side frame.
8. Remove the spring from the large feed roll shaft and remove the
left side frame.
Note: Notice the placement of the spring.
4-12
Service Manual
"Covers and Doors" on
"Covers and Doors" on page
4-11.
"Frames" on
4-15.
4-3.
"Carrier
"Gear Box