Operator Panel Removal - Lexmark Optra Color 45 Service Manual

4080-001
To Reinstall:
1. Hold the memory (SIMM) card with the connection points
toward the connector and position the notch as shown.
2. Insert the memory (SIMM) card all the way into the connector at
a 45° angle, and rotate it down until it snaps into place.
3. Be sure both metal clips on the connector are fastened, and the
two pins on each end are pushed through the holes on the
memory (SIMM) card.

Operator Panel Removal

1. Remove the input / output tray assembly.
2. Remove the front cover, refer to
page 4-3.
3. Disconnect the operator panel cable and note the routing.
4. Remove the four screws securing the operator panel to the front
cover and remove the operator panel.
4-24
Service Manual
"Covers and Doors" on