Operator Panel Cover Removal; Option Card(S) Cover Removal; Rear Cover Removal - Lexmark Optra Color 45 Service Manual

4080-001

Operator Panel Cover Removal

1. Remove the input / output tray assembly.
2. Remove the front cover, refer to the
on page
3. Disconnect the operator panel cable and note the routing.
4. Remove the four screws securing the operator panel to the front
cover, refer to
5. Be sure the front access door is open.
6. Unhook the two plastic guides and lift the operator panel up and
out of the printer.

Option Card(s) Cover Removal

Depress the option card(s) cover and slide it to the rear of the printer
to remove. Refer to the

Rear Cover Removal

1. Remove the input / output tray assembly.
2. Remove the front cover, refer to the
on page
3. Disconnect the operator panel cable and note the routing.
4. Remove the metal and plastic controller board covers, refer to
the "Metal / Plastic Controller Board Cover Removal" on
page 4-7.
5. Unlatch the three plastic rear cover latches located on the top
edge of the carrier frame, refer to
page 4-3.
6. Unlatch the plastic latches from each side of the base assembly.
7. Lift and remove the rear cover.
4-8
Service Manual
4-6.
"Covers and Doors" on page
"Covers and Doors" on page
4-6.
"Front Cover Removal"
4-3.
"Front Cover Removal"
"Covers and Doors" on
4-3.