Encoder / Thermistor Card Removal - Lexmark Optra Color 45 Service Manual

4080-001

Encoder / Thermistor Card Removal

1. Remove the input / output tray assembly.
2. Remove all covers, refer to
3. Move the carrier assembly to the right side of the printer.
4. Disconnect the three printhead cables from the engine board.
5. Remove the carrier shaft retainer clip from the right side of the
carrier shaft.
6. Remove the screw from the left side of the carrier shaft.
7. Remove the carrier shaft by sliding it to the right.
8. Gently lift up on the carrier taking care not to damage the
encoder strip and disconnect the carrier belt.
9. Disconnect the printhead cable from the encoder / thermistor
card.
10. Remove the screw from the encoder / thermistor card and
remove the card.
"Covers and Doors" on page
Repair Information
4-3.
4-21