Printhead Carrier Removal - Lexmark Optra Color 45 Service Manual

4080-001

Printhead Carrier Removal

1. Remove the input / output tray assembly.
2. Remove all covers, refer to
3. Disconnect the three printhead cables from the engine board.
4. Move the carrier assembly to the right side of the printer.
5. Remove the carrier shaft retainer clip from the right side of the
carrier shaft.
6. Remove the screw from the left side of the carrier shaft.
7. Remove the carrier shaft by sliding it to the right.
8. Gently lift up on the printhead carrier, disconnect the carrier belt
and remove the carrier.
Note: When reinstalling the carrier belt, take care not to damage
the encoder strip.
4-30
Service Manual
"Covers and Doors" on page 4-3.