Controller Board Access Cover Removal; Controller Board Access Door Removal; Envelope Guide Removal - Lexmark Optra Color 45 Service Manual

4080-001

Controller Board Access Cover Removal

1. Remove the input / output tray assembly.
2. Remove all covers, refer to
3. Disconnect the operator panel cable and note the routing.
4. Remove the eight screws from the carrier frame assembly and
note the ground strap cable.
5. Disengage the latches located on each side of the carrier frame
assembly, refer to the
6. Slide the carrier frame assembly toward the rear, lift up and
remove it from the base.
7. Remove the two screws from the controller board access cover
and remove.

Controller Board Access Door Removal

1. Remove the input / output tray assembly.
2. Open the front access door, refer to
page 4-3.
3. Remove the paper tray, refer to the
Removal" on page
4. Depress the clip on the controller board access door, and
remove.

Envelope Guide Removal

1. Remove the input / output tray assembly.
2. Open the input / output tray and lift the envelope guide
unclipping it from the lower input tray. Refer to
Doors" on page
"Covers and Doors" on page
"Covers and Doors" on page
4-17.
4-3.
"Covers and Doors" on
"Paper Tray Assembly
"Covers and
Repair Information
4-3.
4-3.
4-5