Troubleshooting - Kyocera COMMAND CENTER Multifunctional Printer Operation Manual

Troubleshooting

50
4 Troubleshooting
Consult the table below to find basic solutions for problems you may encounter with
COMMAND CENTER.
Symptom Check Items
I can't access Is the power turned on
COMMAND to this machine?
CENTER.
Is the network cable
properly connected?
Are the network
settings that are made
in this machine
correct?
Is the IP address for
this machine entered
correctly?
Are the LAN settings
that are made in Web
browser correct?
Has the administrator
set up an IP Filter
function?
Is HTTP Security on
the Advanced >
Security > Secure
Protocol page set to
Secure (HTTPS)?
Does the version of
your browser
application support
operation using
COMMAND
CENTER?
Corrective Action
Turn the power on to
this machine, wait until
it is a ready state, and
try to access
COMMAND CENTER.
Connect the network
cable properly.
Perform the network
settings from the
operation panel.
Contact your network
administrator for the
appropriate settings.
Enter the correct IP
address. Check this
machine IP address
with your network
administrator.
Check the settings
made in Web browser.
Refer to the Help
function in your
browser.
Access COMMAND
CENTER from an
approved IP address.
When HTTP Security is
set to Secure (HTTPS),
specify a URL that
begins with https://. You
cannot access
COMMAND CENTER
with an http:// URL.
Use a browser
application that
supports COMMAND
CENTER.
KYOCERA COMMAND CENTER
Reference
Operation
Guide
Operation
Guide
-
-
-
page 35
page 46
page 1