Advanced - Protocols - Tcp/Ip - Ip Filters - Kyocera COMMAND CENTER Multifunctional Printer Operation Manual

Advanced > Protocols > TCP/IP > IP Filters
Operation Guide
Item
IP Address
Prefix
Length
RA
(Stateless)
Default
Gateway
DHCPv6
(Stateful)
Domain
Name
DNS
Servers
(Primary,
Secondary)
This page allows you to configure IP filters. IP filters restrict access to the printing
system based on the IP addresses and protocols.
Specify the IP addresses or network addresses of the hosts to which access is granted.
If nothing is specified on this page, access from all hosts is allowed.
Item
IP Filter (IPv4)
IP Address
(IPv4)
Subnet
Mask
Description
Assigns an IPv6 address to the printing system network
component.
The format of the IPv6 address is a sequence of numbers
(128 bit in total) separated by colons, e.g.
2001:db8:3c4d:15::1a2c:1a1f.
Specifies the IPv6 prefix length. It can be a decimal value
between 1 and 128.
Select On to use RA instead of the DHCP server to
configure IPv6 addresses.
Specifies the IPv6 address of the default gateway.
Specifies whether or not to obtain IPv6 IP addresses by
automatic configuration. When RA is turned On, the IP
addresses and server information are obtained via DHCPv6
based on the settings of the automatic configuration made
under RA (router setting).
Specifies the DNS (Domain Name System) name of the
domain to which the printing system belongs.
Specifies the IP addresses of the primary and secondary
DNS (Domain Name System) servers. When DHCPv6
(Stateful) is turned On, you can select to use either the DNS
servers obtained via DHCP or the DNS servers being set
under this item.
Description
Specifies the IP address or network address to be permitted.
The number of specifiable entries differs depending on
models.
Specifies the subnet mask to be permitted.
To permit access from all hosts on network 192, enter
"192.0.0.0" for the IP address and "255.0.0.0" for the subnet
mask.
Subnet mask can be left blank.
COMMAND CENTER Pages
35