Kyocera COMMAND CENTER Multifunctional Printer Operation Manual page 53

Operation Guide
Item Description
Specifies whether the lifetime is measured by time or by time
Lifetime
and data size.
Measure-
ment
Specifies the lifetime of an IPSec SA. Lifetime Measurement
Lifetime
allows you to select whether to use time or data size to specify
(Time)/
the lifetime. When you select Time & Data Size, an SA is
Lifetime
disabled and updated when either the time or data size of the
(Data
SA exceeds the specified value.
Size)
Specifies the IP version of the other end. Select IPv4 or IPv6.
IP Version
Specifies the IPv4 addresses of the hosts or network with
IP
which the print system is connecting via IPSec. When you are
Address
restricting the scope of IPSec, be sure to specify the IP
(IPv4)
addresses. If this field is blank, all IPv4 addresses will be
allowed to connect the print system.
Specifies the IPv6 addresses of the hosts or network with
IP
which the print system is connecting via IPSec. When you are
Address
restricting the scope of IPSec, be sure to specify the IP
(IPv6)
addresses. If this field is blank, all IPv6 addresses will be
allowed to connect the print system.
When IPv4 is selected for IP Version, this specifies the
Subnet
subnet mask of the hosts or network with which the print
Mask
system is connecting via IPSec. If this field is blank, the
specified addresses are considered to be host addresses.
When IPv6 is selected for IP Version, this specifies the prefix
Prefix
length of the hosts or network with which the print system is
Length
connecting via IPSec. If this field is blank, the specified
addresses are considered to be host addresses.
COMMAND CENTER Pages
49