Troubleshooting - Kyocera TASKalfa 3051ci User Manual

User Guide

11 Troubleshooting

Consult the table below to find basic solutions for problems you may encounter with the
embedded server.
Symptom Check Items
I can't access Is the power turned on
the embedded to this machine?
server.
Is the network cable
properly connected?
Are the network
settings that are made
in this machine
correct?
Is the IP address for
this machine entered
correctly?
Are the LAN settings
that are made in web
browser correct?
Has the administrator
set up an IP Filter
function?
Is HTTP Security in
Serverside Settings
of the Security
Settings page under
Network Security set
to Secure Only
(HTTPS)?
Corrective Action
Turn the power on to
this machine, wait until
it is in the ready state,
and try to access the
embedded server.
Connect the network
cable properly.
Perform the network
settings from the
operation panel.
Contact your network
administrator for the
appropriate settings.
Enter the correct IP
address. Check this
machine IP address
with your network
administrator.
Check the settings
made in web browser.
Refer to the Help
function in your
browser.
Access the embedded
server from an
approved IP address.
When HTTP Security
is set to Secure Only
(HTTPS), specify a
URL that begins with
https://. You cannot
access the embedded
server with an "http://"
URL.
Troubleshooting
Reference
Operation
Guide
Operation
Guide
-
-
-
IP Filter
(IPv4) on
page 54
IP Filter
(IPv6) on
page 55
Network
Security
Settings
on page
66
87