Advanced - Protocols - Tcp/Ip - General - Kyocera COMMAND CENTER Multifunctional Printer Operation Manual

COMMAND CENTER Pages
Advanced > Protocols > TCP/IP > General
34
The table below provides a summary of the items displayed on the TCP/IP > General page.
Item
Host Name
IPv4 Settings
DHCP/
BOOTP
IP
Address
Subnet
Mask
Default
Gateway
Domain
Name
DNS
Server
(Primary,
Secondary)
WINS
Server
(Primary,
Secondary)
Bonjour
Bonjour
Name
IPv6 Settings
IPv6
Description
Specifies a name for the printing system network component.
This name is also used as the NetBEUI printer name.
Specifies whether or not to automatically obtain an IP
address using DHCP or BOOTP.
Assigns an IPv4 address to the printing system network
component. The format of the IPv4 address is a sequence of
numbers (32-bit in total) separated by dots, e.g.
192.168.110.171.
Specifies the subnet mask.
Specifies the IP address of the default gateway.
Specifies the DNS (Domain Name System) name of the
domain to which the printing system belongs. It should not
contain the host printer name, as in kyoceramita.co.jp.
Specifies the IP addresses of the primary and secondary
DNS (Domain Name System) servers. When DHCP/BOOTP
is turned On, you can select to use either the DNS servers
obtained via DHCP or the DNS servers being set under this
item.
Specifies the IP addresses of the primary and secondary
WINS (Windows Internet Name Service) servers. When
DHCP/BOOTP is turned On, you can select to use either the
WINS server obtained via DHCP or the WINS server being
set under this item.
Specifies whether or not to automatically obtain an IP
address using Bonjour.
You can add a Bonjour printer from the Print Center of Mac
OS X. When using a Windows operating system, you can
use the Bonjour Printer Wizard to add a printer.
The following conditions must be satisfied to automatically
obtain an IP address using Bonjour: If DHCP/BOOTP is
turned Off, an IP address should not be specified. If DHCP/
BOOTP is turned On, automatic IP address assignment by
the DHCP server should not be enabled.
To allow printing from the Mac OS X system, the printer
needs to support KPDL.
If Bonjour is turned On, this specifies the Bonjour name to
be used.
Specifies whether or not to enable the IPv6 protocol.
Select On to use the IPv6 protocol.
KYOCERA COMMAND CENTER