Fujitsu SPARC T5440 User Manual page 77

Fixed ILOM Issues (Continued)
TABLE A-3
CR ID Description
6919764 In System Firmware 7.2.7.b, after the power-on
of a system mounted with the 4Gbps Fibre
Channel card manufactured by Fujitsu, the
message "F20CARD prom is unreadable or
corrupted" may appear in the ILOM event log
and the Service Required LED may turn on.
Solaris OS completes the startup normally, and
the fibre channel card is normally recognized on
Solaris OS.
For details, see
Fujitsu 4Gbps Fibre Channel Card, the Service
Required LED May Turn On after the System
Power-on (CR 6919764)" on page
6913105 When connected to OS console via ILOM, input
or display to console may not be enabled. And at
6908024
this time, output from OS to console may fail.
6942238 When you mount a link card connected to PCI
box and start the system, the slot number is
falsely displayed in the LEDs and FRU Status of
the prtdiag -v command output.
For details, see
Connected to PCI Box Is Falsely Displayed (CR
6942238)" on page
6948680 When you change the system diagnostics
settings (/HOST/diag) from "Remote Control"->
"Diagnostics" tab in the ILOM Web interface, the
value of "Trigger" fails to be set with a pop-up
message "Error:Invalid property value," if the
following value is singly selected for the
"Trigger".
• Power On
• User Reset
"On a System Mounted with the
72.
"Slot Number of Link Card
73.
Workaround
Note - Fixed in System Firmware 7.2.8 or later.
After you insert the power cord, or after the
ILOM reset complete, wait for about 180 seconds
and then power on the system.
Note - Fixed in System Firmware 7.2.8 or later.
After the system stop, disconnect the power cord
and then reconnect the power cord.
Note - Fixed in System Firmware 7.2.10 or later.
None.
This can be safely ignored. To check the fibre
channel card mount, use IO Devices of the
prtdiag command of Solaris OS.
For details, see "Slot Number of Link Card
Connected to PCI Box Is Falsely Displayed (CR
6942238)" on page 73.
Note - Fixed in System Firmware 7.2.10 or later.
None.
Use the set /HOST/diag trigger=
(value) command from the ILOM CLI
interface.
Appendix A Fixed Issues 67