Fujitsu SPARC T5440 User Manual page 69

Fixed Solaris OS Issues (Continued)
TABLE A-2
CR ID Description
6734788 During the system operation, a panic may occur
with the PCIEX-8000-6D message output.
6784914
This occurs more frequently with a high-load
access to the CD/DVD/USB device; however,
even if the DVD drive is not used, vold(1M) of
Solaris OS is accessing to the DVD drive
periodically, and a panic may occur on rare
occasions.
If prtdiag Is Canceled, Subsequent prtdiag
Executions May Fail to Display Status Information
(CR 6552999, 6731560)
This issue is resolved with Solaris patch ID 138082-01 or later, and 139502-02 or later.
If the verbose (-v) option is specified for the control domain prtdiag command,
additional environmental status information will be displayed. If Control-C is
issued to interrupt the output of this information, the picld(1M) daemon may enter
the state in which environmental status information is no longer supplied to
prtdiag. If it does, additional environmental data will no longer be displayed.
Workaround: The following command restarts the picld SMF service. If prtdiag -v
or prtpicl fails to display status information, wait for several minutes, and then
retry or restart picl. Execute prtdiag -v about 10 minutes after picl is restarted.
Method 1: restarting picl
■
# svcadm restart picl
Wait for several minutes.
# prtdiag -v
Method 2: stopping and restarting
■
# svcadm disable svc:/system/picl:default
# rm -rf /var/run/picld_door
# svcadm enable svc:/system/picl:default
Workaround
Note - Fixed in System Firmware 7.2.10.a or
later.
Use the DVD drive only to install the OS or
software or apply a patch or program temporary
fix (PTF).
And stop vold(1M) if the system is running. Stop
of vold(1M) doesn't disrupt the system
operation.
To stop vold(1M), disable the volfs service,
which is a SMF service.
# svcadm disable volfs
To use removable devices such as DVD, execute
the following.
# svcadm enable volfs
Appendix A Fixed Issues 59