Fujitsu SPARC T5440 User Manual page 45

ILOM Issues (Continued)
TABLE 3-4
CR ID Description
6738992 The following warning message may be
displayed when the Components tab of the
ILOM Web interface is opened in Internet
Explorer:
----------------------------------------------------------------
A script on this page is causing
Internet Explorer to run slowly. If it
continues to run, your computer may
become unresponsive.
Do you want to abort the script?
----------------------------------------------------------------
*The actual message may differ.
For the server with system firmware 7.2.2.e or
later, the message may be displayed when
"Show Data in a Single Page" is selected or the
value set in "Rows Per Page" of "Show Table
View Preferences" is too big in the Components
tab.
6739602 If the logdetail property in
/SP/clients/activedirectory is set to a
value other than "none," the following
authentication error message may be displayed
even if ActiveDirectory is set to disabled (state =
disabled):
sc> ActDir | critical: (ActDir)
authentication status: auth-ERROR
6739633 When the host is off, any prepare_to_remove
operation for the component selected in the
ILOM Web interface (System Information tab ->
Components tab) may cause the radio button of
the component to disappear.
In the "Ready to Remove Status" column,
"NotReady" changes to "Ready (No Power)" for
the component, but "Return to Service"
cannot be performed for the component because
the radio button is no longer displayed.
6752910 When a host power-on instruction is executed
from ILOM, the POST (self-diagnostic test) may
not start and the system may proceed to OS boot
processing or the ok prompt for OBP (OpenBoot
PROM).
You can restore the system by resetting ILOM.
Workaround
If you select "Yes", some components will not be
displayed.
Select "No" to display everything.
For the server with system firmware 7.2.2.e or
later, set the smaller value for "Rows Per Page"
or select "Show Data in Multiple Pages" in the
Components tab.
If ActiveDirectory is set to disabled, ignore the
message.
Make the following setting from the CLI:
• set /SYS/(selected-component)
return_to_service_action=true
After turning off the power to the host, wait at
least 3 minutes before turning it on again.
See "After a Host Power-On Instruction Is
Executed from ILOM, the POST May Not Start,
and Processing May Not Go to OS Boot
Processing or the ok Prompt (CR 6752910)" on
page 40.
Chapter 3 Known Issues 35