Fujitsu SPARC T5440 User Manual page 73

Fixed ILOM Issues (Continued)
TABLE A-3
CR ID Description
6733632 The ILOM show -level all/SYS command
does not display information on the
/SYS/MB/SP level or lower. Neither does the
show -level all/SYS/MB command display
information on the /SYS/MB/SP level or lower.
6738989 The SNMP tab of the ILOM Web interface does
not have an item for setting engineid.
6743343 Test Alert generation (alert test transmission)
may not be possible, depending on the "Alert
Type" and "Event" under the alert rule settings.
6729474 The ILOM browser interface powercycle
command does not always appear to allow
enough time for a graceful system power-off.
6692478 Failures may occur in ILOM functions such as
user account management if a prohibited
character like "#", "+", or ":" is used for the first
character of an ILOM user account.
Workaround
Note - Fixed in System Firmware 7.2.2.e or
later.
Use the show /SYS/MB/SP command.
Note - Fixed in System Firmware 7.2.2.e or
later.
Use the "set /SP/services/snmp
engineid=(value)" command from the CLI to
set engineid.
Note - Fixed in System Firmware 7.2.2.e or
later.
None.
Note - Fixed in System Firmware 7.1.8.a or
later.
Check for the availability of a patch for this
defect.
Note - Fixed in System Firmware 7.1.8.a or
later.
None.
When the user account can be deleted, the ILOM
can be recovered by deleting the user account.
When the user can not be deleted, reset the
ILOM configuration to factory defaults to
recover the ILOM.
For the details about procedures and valid
characters for ILOM user accounts, see the
Integrated Lights Out Manager 2.0 User's Guide.
Appendix A Fixed Issues 63