Fujitsu SPARC T5440 User Manual page 48

ILOM Issues (Continued)
TABLE 3-4
CR ID Description
6723410 If you repeat in sequence a login to the service
processor, executing a command, and logging
out, logout may fail.
6837115 On the ILOM Web interface, when you change
the "Alert Management" settings from "Level:
minor" and "Type: IPMI PET" to "Type: SNMP
Trap," the level setting changes to "disable." The
level must be set again.
6881020 When you set /HOST bootfailrecovery to
powercycle, powercycle (host power-off/on)
fails to be executed.
6913388 The ILOM event log may not be in the Solaris
OS system log output (/var/adm/messages).
ILOM login event example:
Nov 7 14:13:03 xxxxxx SC Alert: [ID
178418 daemon.notice] Audit | minor:
admin : Open Session :
object = /session/type : value =
shell : success
Nov 7 14:13:04 xxxxxx SC Alert: [ID
434268 daemon.notice] Audit | minor:
admin : Close Session :
object = /session/type : value =
shell : success
n/a After you remove/insert the power cord and
while POST is running, the "/SYS/XXXXX prom
is unreadable or corrupted" message
may appear and stop at ok prompt. For details,
see "After the Power Cord Removal/Insert, an
Error Message May Appear during the POST"
on page 42.
38 SPARC Enterprise T5440 Server Product Notes • December 2010
Workaround
If this problem occurs, terminate the login
session on the client from which you have
accessed the service processor.
None.
None.
Set to poweroff, wait for the host power turns
off and then manually turn on the host power.
None.
Perform the ILOM reset operation. If not
recovered, shut down the system and then
remove and insert the power cord.
ILOM reset operation example:
Log in to ILOM and execute the following
command.
[In case of ILOM command mode]
-> reset /SP
Are you sure you want to reset /SP
(y/n)? y
[In case of ALOM CMT compatible shell]
sc> resetsc
Are you sure you want to reset the
SC [y/n]? y
Take 180 or more seconds for each of the
intervals between the system power-off and the
power cord removal, and between the removal
and insertion of the power cord.