Fujitsu SPARC T5440 User Manual page 47

ILOM Issues (Continued)
TABLE 3-4
CR ID Description
6726663 In ILOM mode, or through access to the ILOM
Web, it may be possible to change the system
time when the system is powered on.
6823561 In the back up and restore functions of ILOM
settings, you cannot set "https" to the protocol
for data transfer (transfer_method
property).
Example:
-> set dump_uri=
https://ipaddres/directory/filename
set: Unable to transfer image,
please check URI
6830397 In ILOM3.0, you cannot set "service" to the
/HOST/diag mode property or the diag_mode
property of the ALOM CMT compatible shell. If
you set, it is displayed as "unknown."
6835854 In case that the NET-MGT port of ILOM has not
been connected with the LAN cable and the
6779753
network gateway is not set, the ILOM network
configuration cannot be set.
For the output example, see
Network Configuration Cannot Be Set (CR
6835854, 6779753)" on page
Workaround
In ILOM mode, be sure not to change the
properties displayed below at power on so as
not to change the system time directly or enable
NTP services.
-> show /SP/clock
/SP/clock
->
None.
Use other protocols (tftp, ftp, sftp, scp, http).
None.
The following settings offer the POST diagnosis
in a mode equivalent to the "service."
/HOST/diag mode = normal
/HOST diag level = max
/HOST verbosity = max
None.
Connect the LAN cable to the NET-MGT port of
ILOM and then set the network configuration.
"The ILOM
41.
Targets:
Properties:
datetime = Wed Dec 3 06:22:48 2008
usentpserver = disabled
Commands:
cd
set
show
Chapter 3 Known Issues 37