Wiring The Mcu - KVH Industries TracVision G8 Owner's Manual

2.4

Wiring the MCU

All other wiring for the TracVision system connects at the rear
panel of the MCU.
For the TracVision system to work properly, you must connect
the following cables to the MCU:
• Antenna data/power cable
• Vessel power cable
Figure 2-16 shows the MCU's rear panel connectors. Refer to this
figure when wiring components to the MCU.
MCU Rear Panel
Figure 2-16
Antenna
Data/Power
Maintenance Port
(for PC diagnostics)
Connecting the Antenna Data/Power Cable
Connect the antenna data/power cable to the data/power
connector on the MCU's rear panel (see Figure 2-16). Do not
overtighten; finger-tight is sufficient.
54-0198
+ -
Fuse
Vessel Power
RF PCB Software Flashing Port
(technician's use only)
MCU Ground Wire
Installation
35